В результате исследований деформации сжатием стальных образцов с использованием цифровой оптической системы Vic-3D установлено, что при деформации сжатием области локальных деформаций по двум взаимно перпендикулярным направлениям имеют разный характер вблизи торцов испытуемого образца. Следует отметить, что деформации вдоль этих направлений значительно отличаются также и по величине. В центральной части образца формируется овальная область с разным характером распределений микродеформаций в ней. Переход от стадии упругой деформации (область I на деформационной кривой s = f (e)) к пластической сопровождается переходом хаотического множественного распределения пространственных структурных элементов в длинные полосы с характерным распределением на поверхности образца: вдоль макрополос пластической деформации от углов и боковых граней образца в центр. Начиная со стадии I и до середины IV стадии, проявляется ключевая роль макрополос локализованного пластического течения в развитии деформации на поверхности. В конце IV стадии макрополосы пластической деформации вырождаются. Особо подчеркивается, что переход от одной стадии деформации к другой отражается в изменении распределений деформационных полей на поверхности образца и характеризуется изменением значения коэффициента упрочнения.