Phase-transition thermal charging of a channel-shape thermal energy storage unit: Taguchi optimization approach and copper foam inserts

doi:10.3390/molecules26051235

Эндаумент фонд ТГУ!
Впиши своё имя в историю университета
- Сделать пожертвование -

Add to "Quick Collection"

Description	Size	Format
Phase-transition thermal charging of a channel-shape thermal energy storage unit: Taguchi optimization approach and copper foam inserts	9 MB	Adobe Acrobat PDF	Read	Download
DOI Доступ к ресурсу на сайте издателя			10.3390/molecules26051235

#аккумулирование тепловой энергии

#медная пена

#фазовые переходы

Title: Phase-transition thermal charging of a channel-shape thermal energy storage unit: Taguchi optimization approach and copper foam inserts
Creator: Galambaz, Mohammad
|
Mehryan, Seyed Abdollah Mansouri
|
Hajjar, Ahmad
|
Younis, Obai
|
Sheremet, Mikhail A.
|
Pour, Mohsen Saffari
|
Hulme-Smith, Christopher
Date: 2021
DOI: 10.3390/molecules26051235
Description: Thermal energy storage is a technique that has the potential to contribute to future energy grids to reduce fluctuations in supply from renewable energy sources. The principle of energy storage is to drive an endothermic phase change when excess energy is available and to allow the phase change to reverse and release heat when energy demand exceeds supply. Unwanted charge leakage and low heat transfer rates can limit the effectiveness of the units, but both of these problems can be mitigated by incorporating a metal foam into the design of the storage unit. This study demonstrates the benefits of adding copper foam into a thermal energy storage unit based on capric acid enhanced by copper nanoparticles. The volume fraction of nanoparticles and the location and porosity of the foam were optimized using the Taguchi approach to minimize the charge leakage expected from simulations. Placing the foam layer at the bottom of the unit with the maximum possible height and minimum porosity led to the lowest charge time. The optimum concentration of nanoparticles was found to be 4 vol.%, while the maximu possible concentration was 6 vol.%. The use of an optimized design of the enclosure and the optimum fraction of nanoparticles led to a predicted charging time for the unit that was approximately 58% shorter than that of the worst design. A sensitivity analysis shows that the height of the foam layer and its porosity are the dominant variables, and the location of the porous layer and volume fraction of nanoparticles are of secondary importance. Therefore, a well-designed location and size of a metal foam layer could be used to improve the charging speed of thermal energy storage units significantly. In such designs, the porosity and the placement-location of the foam should be considered more strongly than other factors.

Relationships: Show Relationship Browser for this Object
collection(s): Механико-математический факультет
Identifier: смотреть в электронном каталоге НБ ТГУ
Type: статьи в журналах
Source: Molecules. 2021. Vol. 26, № 5. P. 1235 (1-23)
Language: eng

Created: 25-10-2022

1107 Visitors

982 Hits

144 Downloads

Механико-математический факультет Phase-transition thermal charging of a channel-shape thermal energy storage unit: Taguchi optimization approach and copper foam inserts